UK · EU reference Tyre Pressure

215/65R16 · SUV / crossover · kPa

215/65R16 kPa inflation table

Size
215/65R16
Class
SUV / crossover
Planning PSI
33
Planning bar
2.28

kPa

228

2.28 bar · 33 psi · 100 kPa = 1 bar

215/65R16 · 33 psi · 2.28 bar · 228 kPa — estimates. Placard wins.

If the gauge only speaks kPa, 228 kPa is the sketch for this SUV / crossover size. Fine-tune to the vehicle that actually wears 215/65R16. Under-inflation cooks the shoulders of a 215/65R16; over-inflation wears the centre rib and bangs every cat’s eye.

kPa, bar and PSI

Use the table, then set a cold gauge. 228 kPa is 100 × 2.28 bar on this size.

kPaBarPSI
2002.0029
2072.0730
2142.1431
2212.2132
2282.2833
2342.3434
2412.4135
2482.4836
2552.5537
2622.6238
2692.6939
2762.7640
2832.8341
2902.9042
2962.9643
3033.0344
3103.1045

Estimated 215/65R16 pressure by load

Plus-sizing to 215/65R16 from a taller OEM tyre usually keeps the same placard if the load index is equal or higher.

ConditionFront (est.)Rear (est.)
Driver only / unladen33 psi / 2.28 bar / 228 kPa35 psi / 2.41 bar / 241 kPa
Typical occupancy34 psi / 2.34 bar / 234 kPa37 psi / 2.55 bar / 255 kPa
Motorway + luggage (sketch)35 psi / 2.41 bar / 241 kPa38 psi / 2.62 bar / 262 kPa

What 215/65R16 means

Read 215/65R16 as width / aspect R rim. Nothing in the size string is a pressure. Pressure lives on the car, not moulded as 205 or 55.

Compact crossover 16-inch. Rim diameter 16 in; section 215 mm. Estimates on this page assume a typical load index for the SUV / crossover class.

Placard versus sidewall

The sidewall of a 215/65R16 may say 51 psi or 350 kPa. That is a carcass maximum. Operating pressure is the tyre-information placard on the driver’s door pillar.

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 33 psi as a 20 °C baseline for 215/65R16.

AmbientGaugeBarkPaNote
−5 °C (hard frost)30 psi2.07 bar207 kPaGauge reads low; do not overfill once warm
0 °C31 psi2.14 bar214 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)33 psi2.28 bar228 kPaBaseline for this size sketch
30 °C35 psi2.41 bar241 kPaDo not bleed a hot 215/65R16
38 °C (heatwave tarmac)36 psi2.48 bar248 kPaDo not bleed a hot 215/65R16

How to set 215/65R16

  1. Park so the 215/65R16 tyres are cold (three hours, or less than about a mile).
  2. Read the door-pillar placard for that car — not the 215/65R16 sidewall maximum.
  3. If the sticker is missing, 33 psi / 2.28 bar is only a SUV / crossover planning figure for this size.
  4. Set all four with a calibrated gauge. A 3 psi miss on one corner shows up as a wander.
  5. Refit valve caps and reset TPMS if the handbook asks for a relearn.

Cars often seen on 215/65R16

These catalogue models are often seen on 215/65R16 or a close OEM neighbour. Open the vehicle chart for axle-specific PSI and bar.

A cheap gauge and a monthly habit will do more for a set of 215/65R16 than nitrogen upsells.

Questions about 215/65R16

When does TPMS warn on 215/65R16?

Direct TPMS typically flags about 25% below target — near 25 psi if you were aiming at 33. Fill to the sticker, not to the lamp.

Is the sidewall number correct for 215/65R16?

No. Sidewall PSI or kPa is a maximum for the carcass. Operating pressure is the door-pillar placard.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

What is 215/65R16 in bar?

33 psi is 2.28 bar. Add a tenth of a bar if the placard’s laden column is higher, which is common on vans that wear this size.

Is 215/65R16 the same as a plus-size swap?

Only if that is the size you fitted. Overall diameter should stay close to OEM. Pressure still follows the car, with load index at or above original.

Handbook: placard · bar vs PSI · cold inflation · all sizes