UK · EU reference Tyre Pressure

235/60R18 · SUV / crossover · kPa

235/60R18 tyre pressure in kPa

Size
235/60R18
Class
SUV / crossover
Planning PSI
35
Planning bar
2.41

kPa

241

2.41 bar · 35 psi · 100 kPa = 1 bar

235/60R18 · 35 psi · 2.41 bar · 241 kPa — estimates. Placard wins.

Kilopascals show up on some Asian stickers and ISO sheets. 241 kPa is the planning midpoint for 235/60R18 (2.41 bar / 35 psi). 100 kPa = 1 bar. TPMS typically warns near 26 psi (about 25% below a 35 psi target). That is already a soft tyre.

kPa, bar and PSI

Use the table, then set a cold gauge. 241 kPa is 100 × 2.41 bar on this size.

kPaBarPSI
2142.1431
2212.2132
2282.2833
2342.3434
2412.4135
2482.4836
2552.5537
2622.6238
2692.6939
2762.7640
2832.8341
2902.9042
2962.9643
3033.0344
3103.1045
3173.1746
3243.2447

Estimated 235/60R18 pressure by load

Plus-sizing to 235/60R18 from a taller OEM tyre usually keeps the same placard if the load index is equal or higher.

ConditionFront (est.)Rear (est.)
Driver only / unladen35 psi / 2.41 bar / 241 kPa35 psi / 2.41 bar / 241 kPa
Typical occupancy36 psi / 2.48 bar / 248 kPa37 psi / 2.55 bar / 255 kPa
Motorway + luggage (sketch)37 psi / 2.55 bar / 255 kPa38 psi / 2.62 bar / 262 kPa

What 235/60R18 means

A 235/60R18 on a SUV / crossover is a geometry. Two cars can share the size and disagree on PSI because mass and axle split differ.

Plus-size 18-inch SUV. Rim diameter 18 in; section 235 mm. Estimates on this page assume a typical load index for the SUV / crossover class.

Placard versus sidewall

The sidewall of a 235/60R18 may say 51 psi or 350 kPa. That is a carcass maximum. Operating pressure is the tyre-information placard on the driver’s door pillar.

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 35 psi as a 20 °C baseline for 235/60R18.

AmbientGaugeBarkPaNote
−5 °C (hard frost)32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
0 °C33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)34 psi2.34 bar234 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)35 psi2.41 bar241 kPaBaseline for this size sketch
30 °C37 psi2.55 bar255 kPaDo not bleed a hot 235/60R18
38 °C (heatwave tarmac)38 psi2.62 bar262 kPaDo not bleed a hot 235/60R18

How to set 235/60R18

  1. Park so the 235/60R18 tyres are cold (three hours, or less than about a mile).
  2. Read the door-pillar placard for that car — not the 235/60R18 sidewall maximum.
  3. If the sticker is missing, 35 psi / 2.41 bar is only a SUV / crossover planning figure for this size.
  4. Set all four with a calibrated gauge. A 3 psi miss on one corner shows up as a wander.
  5. Refit valve caps and reset TPMS if the handbook asks for a relearn.

Cars often seen on 235/60R18

These catalogue models are often seen on 235/60R18 or a close OEM neighbour. Open the vehicle chart for axle-specific PSI and bar.

Keep 235/60R18 on the printed band for that car; 35 psi is a size sketch, not a second VIN label.

Questions about 235/60R18

When does TPMS warn on 235/60R18?

Direct TPMS typically flags about 25% below target — near 26 psi if you were aiming at 35. Fill to the sticker, not to the lamp.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

What PSI should 235/60R18 tyres be?

A SUV / crossover planning figure is about 35 psi cold (2.41 bar / 241 kPa). Confirm on the vehicle placard — two cars can share 235/60R18 and not share a sticker.

What is 235/60R18 in kPa?

241 kPa is the planning midpoint (100 kPa = 1 bar). 248 kPa is one PSI higher.

Is 235/60R18 the same as a plus-size swap?

Only if that is the size you fitted. Overall diameter should stay close to OEM. Pressure still follows the car, with load index at or above original.

Handbook: placard · bar vs PSI · cold inflation · all sizes