255/45R20 · SUV / crossover · kPa
248 kPa for 255/45R20 tyres
- Size
- 255/45R20
- Class
- SUV / crossover
- Planning PSI
- 36
- Planning bar
- 2.48
kPa
248
2.48 bar · 36 psi · 100 kPa = 1 bar
255/45R20 · 36 psi · 2.48 bar · 248 kPa — estimates. Placard wins.
If the gauge only speaks kPa, 248 kPa is the sketch for this SUV / crossover size. Fine-tune to the vehicle that actually wears 255/45R20. A 10 °C overnight drop takes roughly 1 psi (0.07 bar) off a closed 255/45R20.
kPa, bar and PSI
Use the table, then set a cold gauge. 248 kPa is 100 × 2.48 bar on this size.
| kPa | Bar | PSI |
|---|---|---|
| 221 | 2.21 | 32 |
| 228 | 2.28 | 33 |
| 234 | 2.34 | 34 |
| 241 | 2.41 | 35 |
| 248 | 2.48 | 36 |
| 255 | 2.55 | 37 |
| 262 | 2.62 | 38 |
| 269 | 2.69 | 39 |
| 276 | 2.76 | 40 |
| 283 | 2.83 | 41 |
| 290 | 2.90 | 42 |
| 296 | 2.96 | 43 |
| 303 | 3.03 | 44 |
| 310 | 3.10 | 45 |
| 317 | 3.17 | 46 |
| 324 | 3.24 | 47 |
| 331 | 3.31 | 48 |
Estimated 255/45R20 pressure by load
These 255/45R20 load steps are ± a few PSI from 36. They are not a licence to ignore a printed second column on a van or estate.
| Condition | Front (est.) | Rear (est.) |
|---|---|---|
| Driver only / unladen | 36 psi / 2.48 bar / 248 kPa | 38 psi / 2.62 bar / 262 kPa |
| Typical occupancy | 36 psi / 2.48 bar / 248 kPa | 39 psi / 2.69 bar / 269 kPa |
| Motorway + luggage (sketch) | 37 psi / 2.55 bar / 255 kPa | 40 psi / 2.76 bar / 276 kPa |
What 255/45R20 means
A 255/45R20 on a SUV / crossover is a geometry. Two cars can share the size and disagree on PSI because mass and axle split differ.
20-inch SUV. Rim diameter 20 in; section 255 mm. Estimates on this page assume a typical load index for the SUV / crossover class.
Placard versus sidewall
This website maps size searches such as “255/45R20 psi”. It does not replace the VIN label. If the two disagree, the label wins.
Temperature drift
Roughly 1 psi per 5–6 °C. The table uses 36 psi as a 20 °C baseline for 255/45R20.
| Ambient | Gauge | Bar | kPa | Note |
|---|---|---|---|---|
| −5 °C (hard frost) | 33 psi | 2.28 bar | 228 kPa | Gauge reads low; do not overfill once warm |
| 0 °C | 34 psi | 2.34 bar | 234 kPa | Gauge reads low; do not overfill once warm |
| 8 °C (UK winter morning) | 35 psi | 2.41 bar | 241 kPa | Gauge reads low; do not overfill once warm |
| 20 °C (set cold here) | 36 psi | 2.48 bar | 248 kPa | Baseline for this size sketch |
| 30 °C | 38 psi | 2.62 bar | 262 kPa | Do not bleed a hot 255/45R20 |
| 38 °C (heatwave tarmac) | 39 psi | 2.69 bar | 269 kPa | Do not bleed a hot 255/45R20 |
How to set 255/45R20
- Measure before the school run, not after the motorway.
- Write LF / RF / RR / RL. Do not keep 255/45R20 numbers in your head.
- Add air in short bursts toward the placard, using 36 psi only as a map.
- If one 255/45R20 is 4 psi down, hunt for a nail before you blame the weather.
- Log date, ambient temperature and the four readings.
Cars often seen on 255/45R20
These catalogue models are often seen on 255/45R20 or a close OEM neighbour. Open the vehicle chart for axle-specific PSI and bar.
Keep 255/45R20 on the printed band for that car; 36 psi is a size sketch, not a second VIN label.
Questions about 255/45R20
Should I bleed pressure after a motorway run?
No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.
What is 255/45R20 in kPa?
248 kPa is the planning midpoint (100 kPa = 1 bar). 255 kPa is one PSI higher.
Can I run 255/45R20 at a lower pressure for comfort?
Not as a habit. A soft 255/45R20 cooks the shoulders and dulls steering. Keep load index and stay on the placard.
Is the sidewall number correct for 255/45R20?
No. Sidewall PSI or kPa is a maximum for the carcass. Operating pressure is the door-pillar placard.
What PSI should 255/45R20 tyres be?
A SUV / crossover planning figure is about 36 psi cold (2.48 bar / 248 kPa). Confirm on the vehicle placard — two cars can share 255/45R20 and not share a sticker.
Handbook: placard · bar vs PSI · cold inflation · all sizes