UK · EU reference Tyre Pressure

205/45R16 · passenger car · PSI

205/45R16 tyre pressure in PSI

Size
205/45R16
Class
passenger car
Planning PSI
34
Planning bar
2.34

psi

34

2.34 bar · 234 kPa · passenger car planning figure

205/45R16 · 34 psi · 2.34 bar · 234 kPa — estimates. Placard wins.

If someone typed “205/45R16 psi”, they want Imperial. Start near 34 psi on an unladen passenger car, then confirm the vehicle placard. Sidewall max is not the target. A 10 °C overnight drop takes roughly 1 psi (0.07 bar) off a closed 205/45R16. Low-profile {sz} does not want a “softer” pressure to recover ride. Stay at or slightly above the car’s original placard if load index is kept.

Estimated 205/45R16 pressure by load

Plus-sizing to 205/45R16 from a taller OEM tyre usually keeps the same placard if the load index is equal or higher.

ConditionFront (est.)Rear (est.)
Driver only / unladen34 psi / 2.34 bar / 234 kPa34 psi / 2.34 bar / 234 kPa
Typical occupancy34 psi / 2.34 bar / 234 kPa35 psi / 2.41 bar / 241 kPa
Motorway + luggage (sketch)35 psi / 2.41 bar / 241 kPa36 psi / 2.48 bar / 248 kPa

PSI, bar and kPa

Use the table, then set a cold gauge. 234 kPa is 100 × 2.34 bar on this size.

PSIBarkPa
302.07207
312.14214
322.21221
332.28228
342.34234
352.41241
362.48248
372.55255
382.62262
392.69269
402.76276
412.83283
422.90290
432.96296
443.03303
453.10310
463.17317

What 205/45R16 means

205/45R16 means a 205 millimetre section width, a sidewall that is 45 percent of that width, on a 16-inch rim. The R is radial construction.

Low-profile 16-inch. Rim diameter 16 in; section 205 mm. Estimates on this page assume a typical load index for the passenger car class.

Placard versus sidewall

This website maps size searches such as “205/45R16 psi”. It does not replace the VIN label. If the two disagree, the label wins.

Cars often seen on 205/45R16

These catalogue models are often seen on 205/45R16 or a close OEM neighbour. Open the vehicle chart for axle-specific PSI and bar.

How to set 205/45R16

  1. Measure before the school run, not after the motorway.
  2. Write LF / RF / RR / RL. Do not keep 205/45R16 numbers in your head.
  3. Add air in short bursts toward the placard, using 34 psi only as a map.
  4. If one 205/45R16 is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for 205/45R16.

AmbientGaugeBarkPaNote
−5 °C (hard frost)31 psi2.14 bar214 kPaGauge reads low; do not overfill once warm
0 °C32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)34 psi2.34 bar234 kPaBaseline for this size sketch
30 °C36 psi2.48 bar248 kPaDo not bleed a hot 205/45R16
38 °C (heatwave tarmac)37 psi2.55 bar255 kPaDo not bleed a hot 205/45R16

If the door sticker and this 205/45R16 page disagree, the sticker wins.

Questions about 205/45R16

Is 205/45R16 the same as a plus-size swap?

Only if that is the size you fitted. Overall diameter should stay close to OEM. Pressure still follows the car, with load index at or above original.

When does TPMS warn on 205/45R16?

Direct TPMS typically flags about 25% below target — near 26 psi if you were aiming at 34. Fill to the sticker, not to the lamp.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

What PSI should 205/45R16 tyres be?

A passenger car planning figure is about 34 psi cold (2.34 bar / 234 kPa). Confirm on the vehicle placard — two cars can share 205/45R16 and not share a sticker.

Is the sidewall number correct for 205/45R16?

No. Sidewall PSI or kPa is a maximum for the carcass. Operating pressure is the door-pillar placard.

Handbook: placard · bar vs PSI · cold inflation · all sizes