215/45R16 · passenger car · PSI
What PSI for 215/45R16 tyres?
- Size
- 215/45R16
- Class
- passenger car
- Planning PSI
- 35
- Planning bar
- 2.41
psi
35
2.41 bar · 241 kPa · passenger car planning figure
215/45R16 · 35 psi · 2.41 bar · 241 kPa — estimates. Placard wins.
PSI is the garage-hose number. For 215/45R16 a typical passenger car planning figure is 35 psi cold — about 2.41 bar or 241 kPa. TPMS typically warns near 26 psi (about 25% below a 35 psi target). That is already a soft tyre. Low-profile {sz} does not want a “softer” pressure to recover ride. Stay at or slightly above the car’s original placard if load index is kept.
Estimated 215/45R16 pressure by load
These 215/45R16 load steps are ± a few PSI from 35. They are not a licence to ignore a printed second column on a van or estate.
| Condition | Front (est.) | Rear (est.) |
|---|---|---|
| Driver only / unladen | 35 psi / 2.41 bar / 241 kPa | 35 psi / 2.41 bar / 241 kPa |
| Typical occupancy | 36 psi / 2.48 bar / 248 kPa | 37 psi / 2.55 bar / 255 kPa |
| Motorway + luggage (sketch) | 37 psi / 2.55 bar / 255 kPa | 38 psi / 2.62 bar / 262 kPa |
PSI, bar and kPa
1 bar ≈ 14.5 psi; 1 psi ≈ 6.89 kPa. Planning midpoint for 215/45R16: 35 psi = 2.41 bar = 241 kPa.
| PSI | Bar | kPa |
|---|---|---|
| 31 | 2.14 | 214 |
| 32 | 2.21 | 221 |
| 33 | 2.28 | 228 |
| 34 | 2.34 | 234 |
| 35 | 2.41 | 241 |
| 36 | 2.48 | 248 |
| 37 | 2.55 | 255 |
| 38 | 2.62 | 262 |
| 39 | 2.69 | 269 |
| 40 | 2.76 | 276 |
| 41 | 2.83 | 283 |
| 42 | 2.90 | 290 |
| 43 | 2.96 | 296 |
| 44 | 3.03 | 303 |
| 45 | 3.10 | 310 |
| 46 | 3.17 | 317 |
| 47 | 3.24 | 324 |
What 215/45R16 means
A 215/45R16 on a passenger car is a geometry. Two cars can share the size and disagree on PSI because mass and axle split differ.
Wide low 16-inch. Rim diameter 16 in; section 215 mm. Estimates on this page assume a typical load index for the passenger car class.
Placard versus sidewall
This website maps size searches such as “215/45R16 psi”. It does not replace the VIN label. If the two disagree, the label wins.
Cars often seen on 215/45R16
These catalogue models are often seen on 215/45R16 or a close OEM neighbour. Open the vehicle chart for axle-specific PSI and bar.
How to set 215/45R16
- Park so the 215/45R16 tyres are cold (three hours, or less than about a mile).
- Read the door-pillar placard for that car — not the 215/45R16 sidewall maximum.
- If the sticker is missing, 35 psi / 2.41 bar is only a passenger car planning figure for this size.
- Set all four with a calibrated gauge. A 3 psi miss on one corner shows up as a wander.
- Refit valve caps and reset TPMS if the handbook asks for a relearn.
Temperature drift
Roughly 1 psi per 5–6 °C. The table uses 35 psi as a 20 °C baseline for 215/45R16.
| Ambient | Gauge | Bar | kPa | Note |
|---|---|---|---|---|
| −5 °C (hard frost) | 32 psi | 2.21 bar | 221 kPa | Gauge reads low; do not overfill once warm |
| 0 °C | 33 psi | 2.28 bar | 228 kPa | Gauge reads low; do not overfill once warm |
| 8 °C (UK winter morning) | 34 psi | 2.34 bar | 234 kPa | Gauge reads low; do not overfill once warm |
| 20 °C (set cold here) | 35 psi | 2.41 bar | 241 kPa | Baseline for this size sketch |
| 30 °C | 37 psi | 2.55 bar | 255 kPa | Do not bleed a hot 215/45R16 |
| 38 °C (heatwave tarmac) | 38 psi | 2.62 bar | 262 kPa | Do not bleed a hot 215/45R16 |
Keep 215/45R16 on the printed band for that car; 35 psi is a size sketch, not a second VIN label.
Questions about 215/45R16
Can I run 215/45R16 at a lower pressure for comfort?
Not as a habit. A soft 215/45R16 cooks the shoulders and dulls steering. Keep load index and stay on the placard.
When does TPMS warn on 215/45R16?
Direct TPMS typically flags about 25% below target — near 26 psi if you were aiming at 35. Fill to the sticker, not to the lamp.
What is 215/45R16 in kPa?
241 kPa is the planning midpoint (100 kPa = 1 bar). 248 kPa is one PSI higher.
What PSI should 215/45R16 tyres be?
A passenger car planning figure is about 35 psi cold (2.41 bar / 241 kPa). Confirm on the vehicle placard — two cars can share 215/45R16 and not share a sticker.
Is the sidewall number correct for 215/45R16?
No. Sidewall PSI or kPa is a maximum for the carcass. Operating pressure is the door-pillar placard.
Handbook: placard · bar vs PSI · cold inflation · all sizes