UK · EU reference Tyre Pressure

225/35R19 · passenger car · kPa

248 kPa for 225/35R19 tyres

Size
225/35R19
Class
passenger car
Planning PSI
36
Planning bar
2.48

kPa

248

2.48 bar · 36 psi · 100 kPa = 1 bar

225/35R19 · 36 psi · 2.48 bar · 248 kPa — estimates. Placard wins.

If the gauge only speaks kPa, 248 kPa is the sketch for this passenger car size. Fine-tune to the vehicle that actually wears 225/35R19. Under-inflation cooks the shoulders of a 225/35R19; over-inflation wears the centre rib and bangs every cat’s eye. Low-profile {sz} does not want a “softer” pressure to recover ride. Stay at or slightly above the car’s original placard if load index is kept.

kPa, bar and PSI

1 bar ≈ 14.5 psi; 1 psi ≈ 6.89 kPa. Planning midpoint for 225/35R19: 36 psi = 2.48 bar = 248 kPa.

kPaBarPSI
2212.2132
2282.2833
2342.3434
2412.4135
2482.4836
2552.5537
2622.6238
2692.6939
2762.7640
2832.8341
2902.9042
2962.9643
3033.0344
3103.1045
3173.1746
3243.2447
3313.3148

Estimated 225/35R19 pressure by load

Plus-sizing to 225/35R19 from a taller OEM tyre usually keeps the same placard if the load index is equal or higher.

ConditionFront (est.)Rear (est.)
Driver only / unladen36 psi / 2.48 bar / 248 kPa36 psi / 2.48 bar / 248 kPa
Typical occupancy37 psi / 2.55 bar / 255 kPa38 psi / 2.62 bar / 262 kPa
Motorway + luggage (sketch)38 psi / 2.62 bar / 262 kPa39 psi / 2.69 bar / 269 kPa

What 225/35R19 means

A 225/35R19 on a passenger car is a geometry. Two cars can share the size and disagree on PSI because mass and axle split differ.

Low 19-inch compact. Rim diameter 19 in; section 225 mm. Estimates on this page assume a typical load index for the passenger car class.

Placard versus sidewall

If a forum says “all 225/35R19 run 36 psi”, ignore it. A Qashqai and a Golf can share a size and not share a sticker.

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 36 psi as a 20 °C baseline for 225/35R19.

AmbientGaugeBarkPaNote
−5 °C (hard frost)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
0 °C34 psi2.34 bar234 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)35 psi2.41 bar241 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)36 psi2.48 bar248 kPaBaseline for this size sketch
30 °C38 psi2.62 bar262 kPaDo not bleed a hot 225/35R19
38 °C (heatwave tarmac)39 psi2.69 bar269 kPaDo not bleed a hot 225/35R19

How to set 225/35R19

  1. Measure before the school run, not after the motorway.
  2. Write LF / RF / RR / RL. Do not keep 225/35R19 numbers in your head.
  3. Add air in short bursts toward the placard, using 36 psi only as a map.
  4. If one 225/35R19 is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

Cars often seen on 225/35R19

These catalogue models are often seen on 225/35R19 or a close OEM neighbour. Open the vehicle chart for axle-specific PSI and bar.

If the door sticker and this 225/35R19 page disagree, the sticker wins.

Questions about 225/35R19

Can I run 225/35R19 at a lower pressure for comfort?

Not as a habit. A soft 225/35R19 cooks the shoulders and dulls steering. Keep load index and stay on the placard.

Is the sidewall number correct for 225/35R19?

No. Sidewall PSI or kPa is a maximum for the carcass. Operating pressure is the door-pillar placard.

What is 225/35R19 in kPa?

248 kPa is the planning midpoint (100 kPa = 1 bar). 255 kPa is one PSI higher.

What is 225/35R19 in bar?

36 psi is 2.48 bar. Add a tenth of a bar if the placard’s laden column is higher, which is common on vans that wear this size.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

Handbook: placard · bar vs PSI · cold inflation · all sizes