225/40R17 · passenger car · kPa
225/40R17 tyre pressure in kPa
- Size
- 225/40R17
- Class
- passenger car
- Planning PSI
- 36
- Planning bar
- 2.48
kPa
248
2.48 bar · 36 psi · 100 kPa = 1 bar
225/40R17 · 36 psi · 2.48 bar · 248 kPa — estimates. Placard wins.
Kilopascals show up on some Asian stickers and ISO sheets. 248 kPa is the planning midpoint for 225/40R17 (2.48 bar / 36 psi). 100 kPa = 1 bar. Low-profile 17-inch. These rows are estimates interpolated for the size, not OEM for a named VIN. Low-profile {sz} does not want a “softer” pressure to recover ride. Stay at or slightly above the car’s original placard if load index is kept.
kPa, bar and PSI
Use the table, then set a cold gauge. 248 kPa is 100 × 2.48 bar on this size.
| kPa | Bar | PSI |
|---|---|---|
| 221 | 2.21 | 32 |
| 228 | 2.28 | 33 |
| 234 | 2.34 | 34 |
| 241 | 2.41 | 35 |
| 248 | 2.48 | 36 |
| 255 | 2.55 | 37 |
| 262 | 2.62 | 38 |
| 269 | 2.69 | 39 |
| 276 | 2.76 | 40 |
| 283 | 2.83 | 41 |
| 290 | 2.90 | 42 |
| 296 | 2.96 | 43 |
| 303 | 3.03 | 44 |
| 310 | 3.10 | 45 |
| 317 | 3.17 | 46 |
| 324 | 3.24 | 47 |
| 331 | 3.31 | 48 |
Estimated 225/40R17 pressure by load
Load moves the rear first on a passenger car. If the factory placard already has a laden column, use that — not this sketch for 225/40R17.
| Condition | Front (est.) | Rear (est.) |
|---|---|---|
| Driver only / unladen | 36 psi / 2.48 bar / 248 kPa | 36 psi / 2.48 bar / 248 kPa |
| Typical occupancy | 37 psi / 2.55 bar / 255 kPa | 38 psi / 2.62 bar / 262 kPa |
| Motorway + luggage (sketch) | 38 psi / 2.62 bar / 262 kPa | 39 psi / 2.69 bar / 269 kPa |
What 225/40R17 means
A 225/40R17 on a passenger car is a geometry. Two cars can share the size and disagree on PSI because mass and axle split differ.
Low-profile 17-inch. Rim diameter 17 in; section 225 mm. Estimates on this page assume a typical load index for the passenger car class.
Placard versus sidewall
This website maps size searches such as “225/40R17 psi”. It does not replace the VIN label. If the two disagree, the label wins.
Temperature drift
Roughly 1 psi per 5–6 °C. The table uses 36 psi as a 20 °C baseline for 225/40R17.
| Ambient | Gauge | Bar | kPa | Note |
|---|---|---|---|---|
| −5 °C (hard frost) | 33 psi | 2.28 bar | 228 kPa | Gauge reads low; do not overfill once warm |
| 0 °C | 34 psi | 2.34 bar | 234 kPa | Gauge reads low; do not overfill once warm |
| 8 °C (UK winter morning) | 35 psi | 2.41 bar | 241 kPa | Gauge reads low; do not overfill once warm |
| 20 °C (set cold here) | 36 psi | 2.48 bar | 248 kPa | Baseline for this size sketch |
| 30 °C | 38 psi | 2.62 bar | 262 kPa | Do not bleed a hot 225/40R17 |
| 38 °C (heatwave tarmac) | 39 psi | 2.69 bar | 269 kPa | Do not bleed a hot 225/40R17 |
How to set 225/40R17
- Park so the 225/40R17 tyres are cold (three hours, or less than about a mile).
- Read the door-pillar placard for that car — not the 225/40R17 sidewall maximum.
- If the sticker is missing, 36 psi / 2.48 bar is only a passenger car planning figure for this size.
- Set all four with a calibrated gauge. A 3 psi miss on one corner shows up as a wander.
- Refit valve caps and reset TPMS if the handbook asks for a relearn.
Cars often seen on 225/40R17
These catalogue models are often seen on 225/40R17 or a close OEM neighbour. Open the vehicle chart for axle-specific PSI and bar.
Keep 225/40R17 on the printed band for that car; 36 psi is a size sketch, not a second VIN label.
Questions about 225/40R17
What is 225/40R17 in bar?
36 psi is 2.48 bar. Add a tenth of a bar if the placard’s laden column is higher, which is common on vans that wear this size.
Should I bleed pressure after a motorway run?
No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.
Is 225/40R17 the same as a plus-size swap?
Only if that is the size you fitted. Overall diameter should stay close to OEM. Pressure still follows the car, with load index at or above original.
What PSI should 225/40R17 tyres be?
A passenger car planning figure is about 36 psi cold (2.48 bar / 248 kPa). Confirm on the vehicle placard — two cars can share 225/40R17 and not share a sticker.
What is 225/40R17 in kPa?
248 kPa is the planning midpoint (100 kPa = 1 bar). 255 kPa is one PSI higher.
Handbook: placard · bar vs PSI · cold inflation · all sizes