UK · EU reference Tyre Pressure

225/55R16 · passenger car · Overview

Recommended pressure for 225/55R16 tyres

Size
225/55R16
Class
passenger car
Planning PSI
34
Planning bar
2.34

225/55R16

34 psi / 2.34 bar

234 kPa · estimates for this size class

225/55R16 · 34 psi · 2.34 bar · 234 kPa — estimates. Placard wins.

225/55R16 is a passenger car size (225 mm section, 55 % aspect, 16-inch rim). A planning cold figure around 34 psi / 2.34 bar / 234 kPa is a starting map, not a second factory sticker. Wide 16-inch touring. These rows are estimates interpolated for the size, not OEM for a named VIN.

What 225/55R16 means

225/55R16 means a 225 millimetre section width, a sidewall that is 55 percent of that width, on a 16-inch rim. The R is radial construction.

Wide 16-inch touring. Rim diameter 16 in; section 225 mm. Estimates on this page assume a typical load index for the passenger car class.

Estimated 225/55R16 pressure by load

These 225/55R16 load steps are ± a few PSI from 34. They are not a licence to ignore a printed second column on a van or estate.

ConditionFront (est.)Rear (est.)
Driver only / unladen34 psi / 2.34 bar / 234 kPa34 psi / 2.34 bar / 234 kPa
Typical occupancy35 psi / 2.41 bar / 241 kPa36 psi / 2.48 bar / 248 kPa
Motorway + luggage (sketch)36 psi / 2.48 bar / 248 kPa37 psi / 2.55 bar / 255 kPa

PSI, bar and kPa

Use the table, then set a cold gauge. 234 kPa is 100 × 2.34 bar on this size.

PSIBarkPa
302.07207
312.14214
322.21221
332.28228
342.34234
352.41241
362.48248
372.55255
382.62262
392.69269
402.76276
412.83283
422.90290
432.96296
443.03303
453.10310
463.17317

Placard versus sidewall

This website maps size searches such as “225/55R16 psi”. It does not replace the VIN label. If the two disagree, the label wins.

Cars often seen on 225/55R16

These catalogue models are often seen on 225/55R16 or a close OEM neighbour. Open the vehicle chart for axle-specific PSI and bar.

How to set 225/55R16

  1. Measure before the school run, not after the motorway.
  2. Write LF / RF / RR / RL. Do not keep 225/55R16 numbers in your head.
  3. Add air in short bursts toward the placard, using 34 psi only as a map.
  4. If one 225/55R16 is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for 225/55R16.

AmbientGaugeBarkPaNote
−5 °C (hard frost)31 psi2.14 bar214 kPaGauge reads low; do not overfill once warm
0 °C32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)34 psi2.34 bar234 kPaBaseline for this size sketch
30 °C36 psi2.48 bar248 kPaDo not bleed a hot 225/55R16
38 °C (heatwave tarmac)37 psi2.55 bar255 kPaDo not bleed a hot 225/55R16

Keep 225/55R16 on the printed band for that car; 34 psi is a size sketch, not a second VIN label.

Questions about 225/55R16

Is the sidewall number correct for 225/55R16?

No. Sidewall PSI or kPa is a maximum for the carcass. Operating pressure is the door-pillar placard.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

What is 225/55R16 in bar?

34 psi is 2.34 bar. Add a tenth of a bar if the placard’s laden column is higher, which is common on vans that wear this size.

What PSI should 225/55R16 tyres be?

A passenger car planning figure is about 34 psi cold (2.34 bar / 234 kPa). Confirm on the vehicle placard — two cars can share 225/55R16 and not share a sticker.

When does TPMS warn on 225/55R16?

Direct TPMS typically flags about 25% below target — near 26 psi if you were aiming at 34. Fill to the sticker, not to the lamp.

Handbook: placard · bar vs PSI · cold inflation · all sizes