UK · EU reference Tyre Pressure

225/55R16 · passenger car · PSI

225/55R16 PSI chart (34 psi planning figure)

Size
225/55R16
Class
passenger car
Planning PSI
34
Planning bar
2.34

psi

34

2.34 bar · 234 kPa · passenger car planning figure

225/55R16 · 34 psi · 2.34 bar · 234 kPa — estimates. Placard wins.

If someone typed “225/55R16 psi”, they want Imperial. Start near 34 psi on an unladen passenger car, then confirm the vehicle placard. Sidewall max is not the target. A 10 °C overnight drop takes roughly 1 psi (0.07 bar) off a closed 225/55R16.

Estimated 225/55R16 pressure by load

These 225/55R16 load steps are ± a few PSI from 34. They are not a licence to ignore a printed second column on a van or estate.

ConditionFront (est.)Rear (est.)
Driver only / unladen34 psi / 2.34 bar / 234 kPa34 psi / 2.34 bar / 234 kPa
Typical occupancy35 psi / 2.41 bar / 241 kPa36 psi / 2.48 bar / 248 kPa
Motorway + luggage (sketch)36 psi / 2.48 bar / 248 kPa37 psi / 2.55 bar / 255 kPa

PSI, bar and kPa

Convert around the 225/55R16 band. 2.34 bar is about 34 psi — not 23, not 33 unless the maths says so.

PSIBarkPa
302.07207
312.14214
322.21221
332.28228
342.34234
352.41241
362.48248
372.55255
382.62262
392.69269
402.76276
412.83283
422.90290
432.96296
443.03303
453.10310
463.17317

What 225/55R16 means

225/55R16 means a 225 millimetre section width, a sidewall that is 55 percent of that width, on a 16-inch rim. The R is radial construction.

Wide 16-inch touring. Rim diameter 16 in; section 225 mm. Estimates on this page assume a typical load index for the passenger car class.

Placard versus sidewall

This website maps size searches such as “225/55R16 psi”. It does not replace the VIN label. If the two disagree, the label wins.

Cars often seen on 225/55R16

These catalogue models are often seen on 225/55R16 or a close OEM neighbour. Open the vehicle chart for axle-specific PSI and bar.

How to set 225/55R16

  1. Measure before the school run, not after the motorway.
  2. Write LF / RF / RR / RL. Do not keep 225/55R16 numbers in your head.
  3. Add air in short bursts toward the placard, using 34 psi only as a map.
  4. If one 225/55R16 is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for 225/55R16.

AmbientGaugeBarkPaNote
−5 °C (hard frost)31 psi2.14 bar214 kPaGauge reads low; do not overfill once warm
0 °C32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)34 psi2.34 bar234 kPaBaseline for this size sketch
30 °C36 psi2.48 bar248 kPaDo not bleed a hot 225/55R16
38 °C (heatwave tarmac)37 psi2.55 bar255 kPaDo not bleed a hot 225/55R16

If the door sticker and this 225/55R16 page disagree, the sticker wins.

Questions about 225/55R16

Is the sidewall number correct for 225/55R16?

No. Sidewall PSI or kPa is a maximum for the carcass. Operating pressure is the door-pillar placard.

What PSI should 225/55R16 tyres be?

A passenger car planning figure is about 34 psi cold (2.34 bar / 234 kPa). Confirm on the vehicle placard — two cars can share 225/55R16 and not share a sticker.

Is 225/55R16 the same as a plus-size swap?

Only if that is the size you fitted. Overall diameter should stay close to OEM. Pressure still follows the car, with load index at or above original.

What is 225/55R16 in bar?

34 psi is 2.34 bar. Add a tenth of a bar if the placard’s laden column is higher, which is common on vans that wear this size.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

Handbook: placard · bar vs PSI · cold inflation · all sizes