UK · EU reference Tyre Pressure

225/65R16C · C-type van · Bar

Recommended bar for 225/65R16C

Size
225/65R16C
Class
C-type van
Planning PSI
45
Planning bar
3.1

bar

3.1

45 psi · 310 kPa · not a second factory sticker

225/65R16C · 45 psi · 3.1 bar · 310 kPa — estimates. Placard wins.

European stickers print bar. 225/65R16C often sits near 3.1 bar on a C-type van (45 psi / 310 kPa). 3.1 bar is not “45 divided by ten”. Wider van C-type. These rows are estimates interpolated for the size, not OEM for a named VIN. C-type van tyres (the trailing C) are built for load. Copying a Golf’s 2.3 bar onto a {sz} Transit is how you cook a shoulder on the A1.

Bar, PSI and kPa

Use the table, then set a cold gauge. 310 kPa is 100 × 3.1 bar on this size.

BarPSIkPa
2.8341283
2.9042290
2.9643296
3.0344303
3.1045310
3.1746317
3.2447324
3.3148331
3.3849338
3.4550345
3.5251352
3.5952359
3.6553365
3.7254372
3.7955379
3.8656386
3.9357393
4.1460414
4.4865448
5.5280552

Estimated 225/65R16C pressure by load

These 225/65R16C load steps are ± a few PSI from 45. They are not a licence to ignore a printed second column on a van or estate.

ConditionFront (est.)Rear (est.)
Driver only / unladen45 psi / 3.1 bar / 310 kPa48 psi / 3.31 bar / 331 kPa
Typical occupancy46 psi / 3.17 bar / 317 kPa50 psi / 3.45 bar / 345 kPa
Payload / towing (sketch)47 psi / 3.24 bar / 324 kPa55 psi / 3.79 bar / 379 kPa

Placard versus sidewall

This website maps size searches such as “225/65R16C psi”. It does not replace the VIN label. If the two disagree, the label wins.

What 225/65R16C means

A 225/65R16C on a C-type van is a geometry. Two cars can share the size and disagree on PSI because mass and axle split differ.

Wider van C-type. Rim diameter 16 in; section 225 mm. Estimates on this page assume a typical load index for the C-type van class.

Cars often seen on 225/65R16C

These catalogue models are often seen on 225/65R16C or a close OEM neighbour. Open the vehicle chart for axle-specific PSI and bar.

How to set 225/65R16C

  1. Park so the 225/65R16C tyres are cold (three hours, or less than about a mile).
  2. Read the door-pillar placard for that car — not the 225/65R16C sidewall maximum.
  3. If the sticker is missing, 45 psi / 3.1 bar is only a C-type van planning figure for this size.
  4. Set all four with a calibrated gauge. A 3 psi miss on one corner shows up as a wander.
  5. Refit valve caps and reset TPMS if the handbook asks for a relearn.

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 45 psi as a 20 °C baseline for 225/65R16C.

AmbientGaugeBarkPaNote
−5 °C (hard frost)42 psi2.9 bar290 kPaGauge reads low; do not overfill once warm
0 °C43 psi2.96 bar296 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)44 psi3.03 bar303 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)45 psi3.1 bar310 kPaBaseline for this size sketch
30 °C47 psi3.24 bar324 kPaDo not bleed a hot 225/65R16C
38 °C (heatwave tarmac)48 psi3.31 bar331 kPaDo not bleed a hot 225/65R16C

A cheap gauge and a monthly habit will do more for a set of 225/65R16C than nitrogen upsells.

Questions about 225/65R16C

What is 225/65R16C in kPa?

310 kPa is the planning midpoint (100 kPa = 1 bar). 317 kPa is one PSI higher.

What PSI should 225/65R16C tyres be?

A C-type van planning figure is about 45 psi cold (3.1 bar / 310 kPa). Confirm on the vehicle placard — two cars can share 225/65R16C and not share a sticker.

What is 225/65R16C in bar?

45 psi is 3.1 bar. Add a tenth of a bar if the placard’s laden column is higher, which is common on vans that wear this size.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

Is 225/65R16C the same as a plus-size swap?

Only if that is the size you fitted. Overall diameter should stay close to OEM. Pressure still follows the car, with load index at or above original.

Handbook: placard · bar vs PSI · cold inflation · all sizes