215/75R16C · C-type van · Bar
215/75R16C bar chart (3.17 bar planning figure)
- Size
- 215/75R16C
- Class
- C-type van
- Planning PSI
- 46
- Planning bar
- 3.17
bar
3.17
46 psi · 317 kPa · not a second factory sticker
215/75R16C · 46 psi · 3.17 bar · 317 kPa — estimates. Placard wins.
A 215/75R16C C-type or LT carcass can live far above a hatchback bar figure. This page’s 3.17 bar sketch is for the C-type van class, not every car that can physically mount the tyre. A 10 °C overnight drop takes roughly 1 psi (0.07 bar) off a closed 215/75R16C. C-type van tyres (the trailing C) are built for load. Copying a Golf’s 2.3 bar onto a {sz} Transit is how you cook a shoulder on the A1.
Bar, PSI and kPa
Use the table, then set a cold gauge. 317 kPa is 100 × 3.17 bar on this size.
| Bar | PSI | kPa |
|---|---|---|
| 2.90 | 42 | 290 |
| 2.96 | 43 | 296 |
| 3.03 | 44 | 303 |
| 3.10 | 45 | 310 |
| 3.17 | 46 | 317 |
| 3.24 | 47 | 324 |
| 3.31 | 48 | 331 |
| 3.38 | 49 | 338 |
| 3.45 | 50 | 345 |
| 3.52 | 51 | 352 |
| 3.59 | 52 | 359 |
| 3.65 | 53 | 365 |
| 3.72 | 54 | 372 |
| 3.79 | 55 | 379 |
| 3.86 | 56 | 386 |
| 3.93 | 57 | 393 |
| 4.00 | 58 | 400 |
| 4.14 | 60 | 414 |
| 4.48 | 65 | 448 |
| 5.52 | 80 | 552 |
Estimated 215/75R16C pressure by load
Plus-sizing to 215/75R16C from a taller OEM tyre usually keeps the same placard if the load index is equal or higher.
| Condition | Front (est.) | Rear (est.) |
|---|---|---|
| Driver only / unladen | 46 psi / 3.17 bar / 317 kPa | 49 psi / 3.38 bar / 338 kPa |
| Typical occupancy | 46 psi / 3.17 bar / 317 kPa | 50 psi / 3.45 bar / 345 kPa |
| Payload / towing (sketch) | 47 psi / 3.24 bar / 324 kPa | 55 psi / 3.79 bar / 379 kPa |
Placard versus sidewall
This website maps size searches such as “215/75R16C psi”. It does not replace the VIN label. If the two disagree, the label wins.
What 215/75R16C means
215/75R16C means a 215 millimetre section width, a sidewall that is 75 percent of that width, on a 16-inch rim. The R is radial construction.
Loaded van C-type 215. Rim diameter 16 in; section 215 mm. Estimates on this page assume a typical load index for the C-type van class.
Cars often seen on 215/75R16C
These catalogue models are often seen on 215/75R16C or a close OEM neighbour. Open the vehicle chart for axle-specific PSI and bar.
How to set 215/75R16C
- Park so the 215/75R16C tyres are cold (three hours, or less than about a mile).
- Read the door-pillar placard for that car — not the 215/75R16C sidewall maximum.
- If the sticker is missing, 46 psi / 3.17 bar is only a C-type van planning figure for this size.
- Set all four with a calibrated gauge. A 3 psi miss on one corner shows up as a wander.
- Refit valve caps and reset TPMS if the handbook asks for a relearn.
Temperature drift
Roughly 1 psi per 5–6 °C. The table uses 46 psi as a 20 °C baseline for 215/75R16C.
| Ambient | Gauge | Bar | kPa | Note |
|---|---|---|---|---|
| −5 °C (hard frost) | 43 psi | 2.96 bar | 296 kPa | Gauge reads low; do not overfill once warm |
| 0 °C | 44 psi | 3.03 bar | 303 kPa | Gauge reads low; do not overfill once warm |
| 8 °C (UK winter morning) | 45 psi | 3.1 bar | 310 kPa | Gauge reads low; do not overfill once warm |
| 20 °C (set cold here) | 46 psi | 3.17 bar | 317 kPa | Baseline for this size sketch |
| 30 °C | 48 psi | 3.31 bar | 331 kPa | Do not bleed a hot 215/75R16C |
| 38 °C (heatwave tarmac) | 49 psi | 3.38 bar | 338 kPa | Do not bleed a hot 215/75R16C |
Keep 215/75R16C on the printed band for that car; 46 psi is a size sketch, not a second VIN label.
Questions about 215/75R16C
Can I run 215/75R16C at a lower pressure for comfort?
Not as a habit. A soft 215/75R16C cooks the shoulders and dulls steering. Keep load index and stay on the placard.
Is 215/75R16C the same as a plus-size swap?
Only if that is the size you fitted. Overall diameter should stay close to OEM. Pressure still follows the car, with load index at or above original.
What PSI should 215/75R16C tyres be?
A C-type van planning figure is about 46 psi cold (3.17 bar / 317 kPa). Confirm on the vehicle placard — two cars can share 215/75R16C and not share a sticker.
Is the sidewall number correct for 215/75R16C?
No. Sidewall PSI or kPa is a maximum for the carcass. Operating pressure is the door-pillar placard.
What is 215/75R16C in kPa?
317 kPa is the planning midpoint (100 kPa = 1 bar). 324 kPa is one PSI higher.
Handbook: placard · bar vs PSI · cold inflation · all sizes