UK · EU reference Tyre Pressure

235/65R17 · SUV / crossover · PSI

235/65R17 PSI chart (35 psi planning figure)

Size
235/65R17
Class
SUV / crossover
Planning PSI
35
Planning bar
2.41

psi

35

2.41 bar · 241 kPa · SUV / crossover planning figure

235/65R17 · 35 psi · 2.41 bar · 241 kPa — estimates. Placard wins.

PSI is the garage-hose number. For 235/65R17 a typical SUV / crossover planning figure is 35 psi cold — about 2.41 bar or 241 kPa. Common mid-size SUV. These rows are estimates interpolated for the size, not OEM for a named VIN.

Estimated 235/65R17 pressure by load

Load moves the rear first on a SUV / crossover. If the factory placard already has a laden column, use that — not this sketch for 235/65R17.

ConditionFront (est.)Rear (est.)
Driver only / unladen35 psi / 2.41 bar / 241 kPa35 psi / 2.41 bar / 241 kPa
Typical occupancy35 psi / 2.41 bar / 241 kPa36 psi / 2.48 bar / 248 kPa
Motorway + luggage (sketch)36 psi / 2.48 bar / 248 kPa37 psi / 2.55 bar / 255 kPa

PSI, bar and kPa

Convert around the 235/65R17 band. 2.41 bar is about 35 psi — not 23, not 33 unless the maths says so.

PSIBarkPa
312.14214
322.21221
332.28228
342.34234
352.41241
362.48248
372.55255
382.62262
392.69269
402.76276
412.83283
422.90290
432.96296
443.03303
453.10310
463.17317
473.24324

What 235/65R17 means

235/65R17 means a 235 millimetre section width, a sidewall that is 65 percent of that width, on a 17-inch rim. The R is radial construction.

Common mid-size SUV. Rim diameter 17 in; section 235 mm. Estimates on this page assume a typical load index for the SUV / crossover class.

Placard versus sidewall

This website maps size searches such as “235/65R17 psi”. It does not replace the VIN label. If the two disagree, the label wins.

Cars often seen on 235/65R17

These catalogue models are often seen on 235/65R17 or a close OEM neighbour. Open the vehicle chart for axle-specific PSI and bar.

How to set 235/65R17

  1. Measure before the school run, not after the motorway.
  2. Write LF / RF / RR / RL. Do not keep 235/65R17 numbers in your head.
  3. Add air in short bursts toward the placard, using 35 psi only as a map.
  4. If one 235/65R17 is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 35 psi as a 20 °C baseline for 235/65R17.

AmbientGaugeBarkPaNote
−5 °C (hard frost)32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
0 °C33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)34 psi2.34 bar234 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)35 psi2.41 bar241 kPaBaseline for this size sketch
30 °C37 psi2.55 bar255 kPaDo not bleed a hot 235/65R17
38 °C (heatwave tarmac)38 psi2.62 bar262 kPaDo not bleed a hot 235/65R17

Keep 235/65R17 on the printed band for that car; 35 psi is a size sketch, not a second VIN label.

Questions about 235/65R17

Is 235/65R17 the same as a plus-size swap?

Only if that is the size you fitted. Overall diameter should stay close to OEM. Pressure still follows the car, with load index at or above original.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

Is the sidewall number correct for 235/65R17?

No. Sidewall PSI or kPa is a maximum for the carcass. Operating pressure is the door-pillar placard.

What PSI should 235/65R17 tyres be?

A SUV / crossover planning figure is about 35 psi cold (2.41 bar / 241 kPa). Confirm on the vehicle placard — two cars can share 235/65R17 and not share a sticker.

Can I run 235/65R17 at a lower pressure for comfort?

Not as a habit. A soft 235/65R17 cooks the shoulders and dulls steering. Keep load index and stay on the placard.

Handbook: placard · bar vs PSI · cold inflation · all sizes