UK · EU reference Tyre Pressure

275/70R18 · pickup / double-cab · kPa

275/70R18 tyre pressure in kPa

Size
275/70R18
Class
pickup / double-cab
Planning PSI
37
Planning bar
2.55

kPa

255

2.55 bar · 37 psi · 100 kPa = 1 bar

275/70R18 · 37 psi · 2.55 bar · 255 kPa — estimates. Placard wins.

Kilopascals show up on some Asian stickers and ISO sheets. 255 kPa is the planning midpoint for 275/70R18 (2.55 bar / 37 psi). 100 kPa = 1 bar. Heavier rear-bias 18-inch truck. These rows are estimates interpolated for the size, not OEM for a named VIN.

kPa, bar and PSI

1 bar ≈ 14.5 psi; 1 psi ≈ 6.89 kPa. Planning midpoint for 275/70R18: 37 psi = 2.55 bar = 255 kPa.

kPaBarPSI
2282.2833
2342.3434
2412.4135
2482.4836
2552.5537
2622.6238
2692.6939
2762.7640
2832.8341
2902.9042
2962.9643
3033.0344
3103.1045
3173.1746
3243.2447
3313.3148
3383.3849

Estimated 275/70R18 pressure by load

Load moves the rear first on a pickup / double-cab. If the factory placard already has a laden column, use that — not this sketch for 275/70R18.

ConditionFront (est.)Rear (est.)
Driver only / unladen37 psi / 2.55 bar / 255 kPa39 psi / 2.69 bar / 269 kPa
Typical occupancy37 psi / 2.55 bar / 255 kPa40 psi / 2.76 bar / 276 kPa
Payload / towing (sketch)38 psi / 2.62 bar / 262 kPa41 psi / 2.83 bar / 283 kPa

What 275/70R18 means

Read 275/70R18 as width / aspect R rim. Nothing in the size string is a pressure. Pressure lives on the car, not moulded as 205 or 55.

Heavier rear-bias 18-inch truck. Rim diameter 18 in; section 275 mm. Estimates on this page assume a typical load index for the pickup / double-cab class.

Placard versus sidewall

The sidewall of a 275/70R18 may say 51 psi or 350 kPa. That is a carcass maximum. Operating pressure is the tyre-information placard on the driver’s door pillar.

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 37 psi as a 20 °C baseline for 275/70R18.

AmbientGaugeBarkPaNote
−5 °C (hard frost)34 psi2.34 bar234 kPaGauge reads low; do not overfill once warm
0 °C35 psi2.41 bar241 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)36 psi2.48 bar248 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)37 psi2.55 bar255 kPaBaseline for this size sketch
30 °C39 psi2.69 bar269 kPaDo not bleed a hot 275/70R18
38 °C (heatwave tarmac)40 psi2.76 bar276 kPaDo not bleed a hot 275/70R18

How to set 275/70R18

  1. Measure before the school run, not after the motorway.
  2. Write LF / RF / RR / RL. Do not keep 275/70R18 numbers in your head.
  3. Add air in short bursts toward the placard, using 37 psi only as a map.
  4. If one 275/70R18 is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

Cars often seen on 275/70R18

These catalogue models are often seen on 275/70R18 or a close OEM neighbour. Open the vehicle chart for axle-specific PSI and bar.

If the door sticker and this 275/70R18 page disagree, the sticker wins.

Questions about 275/70R18

What is 275/70R18 in bar?

37 psi is 2.55 bar. Add a tenth of a bar if the placard’s laden column is higher, which is common on vans that wear this size.

When does TPMS warn on 275/70R18?

Direct TPMS typically flags about 25% below target — near 28 psi if you were aiming at 37. Fill to the sticker, not to the lamp.

Is 275/70R18 the same as a plus-size swap?

Only if that is the size you fitted. Overall diameter should stay close to OEM. Pressure still follows the car, with load index at or above original.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

What PSI should 275/70R18 tyres be?

A pickup / double-cab planning figure is about 37 psi cold (2.55 bar / 255 kPa). Confirm on the vehicle placard — two cars can share 275/70R18 and not share a sticker.

Handbook: placard · bar vs PSI · cold inflation · all sizes