UK · EU reference Tyre Pressure

225/45R18 · passenger car · PSI

What PSI for 225/45R18 tyres?

Size
225/45R18
Class
passenger car
Planning PSI
36
Planning bar
2.48

psi

36

2.48 bar · 248 kPa · passenger car planning figure

225/45R18 · 36 psi · 2.48 bar · 248 kPa — estimates. Placard wins.

If someone typed “225/45R18 psi”, they want Imperial. Start near 36 psi on an unladen passenger car, then confirm the vehicle placard. Sidewall max is not the target. A 10 °C overnight drop takes roughly 1 psi (0.07 bar) off a closed 225/45R18. Low-profile {sz} does not want a “softer” pressure to recover ride. Stay at or slightly above the car’s original placard if load index is kept.

Estimated 225/45R18 pressure by load

These 225/45R18 load steps are ± a few PSI from 36. They are not a licence to ignore a printed second column on a van or estate.

ConditionFront (est.)Rear (est.)
Driver only / unladen36 psi / 2.48 bar / 248 kPa36 psi / 2.48 bar / 248 kPa
Typical occupancy36 psi / 2.48 bar / 248 kPa37 psi / 2.55 bar / 255 kPa
Motorway + luggage (sketch)37 psi / 2.55 bar / 255 kPa38 psi / 2.62 bar / 262 kPa

PSI, bar and kPa

1 bar ≈ 14.5 psi; 1 psi ≈ 6.89 kPa. Planning midpoint for 225/45R18: 36 psi = 2.48 bar = 248 kPa.

PSIBarkPa
322.21221
332.28228
342.34234
352.41241
362.48248
372.55255
382.62262
392.69269
402.76276
412.83283
422.90290
432.96296
443.03303
453.10310
463.17317
473.24324
483.31331

What 225/45R18 means

Read 225/45R18 as width / aspect R rim. Nothing in the size string is a pressure. Pressure lives on the car, not moulded as 205 or 55.

18-inch sport compact / EV. Rim diameter 18 in; section 225 mm. Estimates on this page assume a typical load index for the passenger car class.

Placard versus sidewall

This website maps size searches such as “225/45R18 psi”. It does not replace the VIN label. If the two disagree, the label wins.

Cars often seen on 225/45R18

These catalogue models are often seen on 225/45R18 or a close OEM neighbour. Open the vehicle chart for axle-specific PSI and bar.

How to set 225/45R18

  1. Measure before the school run, not after the motorway.
  2. Write LF / RF / RR / RL. Do not keep 225/45R18 numbers in your head.
  3. Add air in short bursts toward the placard, using 36 psi only as a map.
  4. If one 225/45R18 is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 36 psi as a 20 °C baseline for 225/45R18.

AmbientGaugeBarkPaNote
−5 °C (hard frost)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
0 °C34 psi2.34 bar234 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)35 psi2.41 bar241 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)36 psi2.48 bar248 kPaBaseline for this size sketch
30 °C38 psi2.62 bar262 kPaDo not bleed a hot 225/45R18
38 °C (heatwave tarmac)39 psi2.69 bar269 kPaDo not bleed a hot 225/45R18

Keep 225/45R18 on the printed band for that car; 36 psi is a size sketch, not a second VIN label.

Questions about 225/45R18

Is 225/45R18 the same as a plus-size swap?

Only if that is the size you fitted. Overall diameter should stay close to OEM. Pressure still follows the car, with load index at or above original.

Is the sidewall number correct for 225/45R18?

No. Sidewall PSI or kPa is a maximum for the carcass. Operating pressure is the door-pillar placard.

What is 225/45R18 in bar?

36 psi is 2.48 bar. Add a tenth of a bar if the placard’s laden column is higher, which is common on vans that wear this size.

When does TPMS warn on 225/45R18?

Direct TPMS typically flags about 25% below target — near 27 psi if you were aiming at 36. Fill to the sticker, not to the lamp.

Can I run 225/45R18 at a lower pressure for comfort?

Not as a habit. A soft 225/45R18 cooks the shoulders and dulls steering. Keep load index and stay on the placard.

Handbook: placard · bar vs PSI · cold inflation · all sizes