UK · EU reference Tyre Pressure

225/75R16C · C-type van · kPa

225/75R16C kPa inflation table

Size
225/75R16C
Class
C-type van
Planning PSI
47
Planning bar
3.24

kPa

324

3.24 bar · 47 psi · 100 kPa = 1 bar

225/75R16C · 47 psi · 3.24 bar · 324 kPa — estimates. Placard wins.

Kilopascals show up on some Asian stickers and ISO sheets. 324 kPa is the planning midpoint for 225/75R16C (3.24 bar / 47 psi). 100 kPa = 1 bar. Taller load-range van. These rows are estimates interpolated for the size, not OEM for a named VIN. C-type van tyres (the trailing C) are built for load. Copying a Golf’s 2.3 bar onto a {sz} Transit is how you cook a shoulder on the A1.

kPa, bar and PSI

Convert around the 225/75R16C band. 3.24 bar is about 47 psi — not 23, not 33 unless the maths says so.

kPaBarPSI
2962.9643
3033.0344
3103.1045
3173.1746
3243.2447
3313.3148
3383.3849
3453.4550
3523.5251
3593.5952
3653.6553
3723.7254
3793.7955
3863.8656
3933.9357
4004.0058
4074.0759
4144.1460
4484.4865
5525.5280

Estimated 225/75R16C pressure by load

Plus-sizing to 225/75R16C from a taller OEM tyre usually keeps the same placard if the load index is equal or higher.

ConditionFront (est.)Rear (est.)
Driver only / unladen47 psi / 3.24 bar / 324 kPa51 psi / 3.52 bar / 352 kPa
Typical occupancy47 psi / 3.24 bar / 324 kPa52 psi / 3.59 bar / 359 kPa
Payload / towing (sketch)48 psi / 3.31 bar / 331 kPa57 psi / 3.93 bar / 393 kPa

What 225/75R16C means

225/75R16C means a 225 millimetre section width, a sidewall that is 75 percent of that width, on a 16-inch rim. The R is radial construction.

Taller load-range van. Rim diameter 16 in; section 225 mm. Estimates on this page assume a typical load index for the C-type van class.

Placard versus sidewall

This website maps size searches such as “225/75R16C psi”. It does not replace the VIN label. If the two disagree, the label wins.

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 47 psi as a 20 °C baseline for 225/75R16C.

AmbientGaugeBarkPaNote
−5 °C (hard frost)44 psi3.03 bar303 kPaGauge reads low; do not overfill once warm
0 °C45 psi3.1 bar310 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)46 psi3.17 bar317 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)47 psi3.24 bar324 kPaBaseline for this size sketch
30 °C49 psi3.38 bar338 kPaDo not bleed a hot 225/75R16C
38 °C (heatwave tarmac)50 psi3.45 bar345 kPaDo not bleed a hot 225/75R16C

How to set 225/75R16C

  1. Measure before the school run, not after the motorway.
  2. Write LF / RF / RR / RL. Do not keep 225/75R16C numbers in your head.
  3. Add air in short bursts toward the placard, using 47 psi only as a map.
  4. If one 225/75R16C is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

Cars often seen on 225/75R16C

These catalogue models are often seen on 225/75R16C or a close OEM neighbour. Open the vehicle chart for axle-specific PSI and bar.

A cheap gauge and a monthly habit will do more for a set of 225/75R16C than nitrogen upsells.

Questions about 225/75R16C

Is the sidewall number correct for 225/75R16C?

No. Sidewall PSI or kPa is a maximum for the carcass. Operating pressure is the door-pillar placard.

Is 225/75R16C the same as a plus-size swap?

Only if that is the size you fitted. Overall diameter should stay close to OEM. Pressure still follows the car, with load index at or above original.

When does TPMS warn on 225/75R16C?

Direct TPMS typically flags about 25% below target — near 35 psi if you were aiming at 47. Fill to the sticker, not to the lamp.

What is 225/75R16C in kPa?

324 kPa is the planning midpoint (100 kPa = 1 bar). 331 kPa is one PSI higher.

Can I run 225/75R16C at a lower pressure for comfort?

Not as a habit. A soft 225/75R16C cooks the shoulders and dulls steering. Keep load index and stay on the placard.

Handbook: placard · bar vs PSI · cold inflation · all sizes