UK · EU reference Tyre Pressure

225/75R16C · C-type van · PSI

What PSI for 225/75R16C tyres?

Size
225/75R16C
Class
C-type van
Planning PSI
47
Planning bar
3.24

psi

47

3.24 bar · 324 kPa · C-type van planning figure

225/75R16C · 47 psi · 3.24 bar · 324 kPa — estimates. Placard wins.

PSI is the garage-hose number. For 225/75R16C a typical C-type van planning figure is 47 psi cold — about 3.24 bar or 324 kPa. Taller load-range van. These rows are estimates interpolated for the size, not OEM for a named VIN. C-type van tyres (the trailing C) are built for load. Copying a Golf’s 2.3 bar onto a {sz} Transit is how you cook a shoulder on the A1.

Estimated 225/75R16C pressure by load

These 225/75R16C load steps are ± a few PSI from 47. They are not a licence to ignore a printed second column on a van or estate.

ConditionFront (est.)Rear (est.)
Driver only / unladen47 psi / 3.24 bar / 324 kPa49 psi / 3.38 bar / 338 kPa
Typical occupancy47 psi / 3.24 bar / 324 kPa50 psi / 3.45 bar / 345 kPa
Payload / towing (sketch)48 psi / 3.31 bar / 331 kPa55 psi / 3.79 bar / 379 kPa

PSI, bar and kPa

Convert around the 225/75R16C band. 3.24 bar is about 47 psi — not 23, not 33 unless the maths says so.

PSIBarkPa
432.96296
443.03303
453.10310
463.17317
473.24324
483.31331
493.38338
503.45345
513.52352
523.59359
533.65365
543.72372
553.79379
563.86386
573.93393
584.00400
594.07407
604.14414
654.48448
805.52552

What 225/75R16C means

225/75R16C means a 225 millimetre section width, a sidewall that is 75 percent of that width, on a 16-inch rim. The R is radial construction.

Taller load-range van. Rim diameter 16 in; section 225 mm. Estimates on this page assume a typical load index for the C-type van class.

Placard versus sidewall

If a forum says “all 225/75R16C run 47 psi”, ignore it. A Qashqai and a Golf can share a size and not share a sticker.

Cars often seen on 225/75R16C

These catalogue models are often seen on 225/75R16C or a close OEM neighbour. Open the vehicle chart for axle-specific PSI and bar.

How to set 225/75R16C

  1. Park so the 225/75R16C tyres are cold (three hours, or less than about a mile).
  2. Read the door-pillar placard for that car — not the 225/75R16C sidewall maximum.
  3. If the sticker is missing, 47 psi / 3.24 bar is only a C-type van planning figure for this size.
  4. Set all four with a calibrated gauge. A 3 psi miss on one corner shows up as a wander.
  5. Refit valve caps and reset TPMS if the handbook asks for a relearn.

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 47 psi as a 20 °C baseline for 225/75R16C.

AmbientGaugeBarkPaNote
−5 °C (hard frost)44 psi3.03 bar303 kPaGauge reads low; do not overfill once warm
0 °C45 psi3.1 bar310 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)46 psi3.17 bar317 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)47 psi3.24 bar324 kPaBaseline for this size sketch
30 °C49 psi3.38 bar338 kPaDo not bleed a hot 225/75R16C
38 °C (heatwave tarmac)50 psi3.45 bar345 kPaDo not bleed a hot 225/75R16C

If the door sticker and this 225/75R16C page disagree, the sticker wins.

Questions about 225/75R16C

Is the sidewall number correct for 225/75R16C?

No. Sidewall PSI or kPa is a maximum for the carcass. Operating pressure is the door-pillar placard.

What PSI should 225/75R16C tyres be?

A C-type van planning figure is about 47 psi cold (3.24 bar / 324 kPa). Confirm on the vehicle placard — two cars can share 225/75R16C and not share a sticker.

What is 225/75R16C in kPa?

324 kPa is the planning midpoint (100 kPa = 1 bar). 331 kPa is one PSI higher.

When does TPMS warn on 225/75R16C?

Direct TPMS typically flags about 25% below target — near 35 psi if you were aiming at 47. Fill to the sticker, not to the lamp.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

Handbook: placard · bar vs PSI · cold inflation · all sizes