UK · EU reference Tyre Pressure

215/75R16C · C-type van · kPa

215/75R16C kPa inflation table

Size
215/75R16C
Class
C-type van
Planning PSI
46
Planning bar
3.17

kPa

317

3.17 bar · 46 psi · 100 kPa = 1 bar

215/75R16C · 46 psi · 3.17 bar · 317 kPa — estimates. Placard wins.

If the gauge only speaks kPa, 317 kPa is the sketch for this C-type van size. Fine-tune to the vehicle that actually wears 215/75R16C. Under-inflation cooks the shoulders of a 215/75R16C; over-inflation wears the centre rib and bangs every cat’s eye. C-type van tyres (the trailing C) are built for load. Copying a Golf’s 2.3 bar onto a {sz} Transit is how you cook a shoulder on the A1.

kPa, bar and PSI

1 bar ≈ 14.5 psi; 1 psi ≈ 6.89 kPa. Planning midpoint for 215/75R16C: 46 psi = 3.17 bar = 317 kPa.

kPaBarPSI
2902.9042
2962.9643
3033.0344
3103.1045
3173.1746
3243.2447
3313.3148
3383.3849
3453.4550
3523.5251
3593.5952
3653.6553
3723.7254
3793.7955
3863.8656
3933.9357
4004.0058
4144.1460
4484.4865
5525.5280

Estimated 215/75R16C pressure by load

These 215/75R16C load steps are ± a few PSI from 46. They are not a licence to ignore a printed second column on a van or estate.

ConditionFront (est.)Rear (est.)
Driver only / unladen46 psi / 3.17 bar / 317 kPa48 psi / 3.31 bar / 331 kPa
Typical occupancy46 psi / 3.17 bar / 317 kPa49 psi / 3.38 bar / 338 kPa
Payload / towing (sketch)47 psi / 3.24 bar / 324 kPa54 psi / 3.72 bar / 372 kPa

What 215/75R16C means

Read 215/75R16C as width / aspect R rim. Nothing in the size string is a pressure. Pressure lives on the car, not moulded as 205 or 55.

Loaded van C-type 215. Rim diameter 16 in; section 215 mm. Estimates on this page assume a typical load index for the C-type van class.

Placard versus sidewall

The sidewall of a 215/75R16C may say 51 psi or 350 kPa. That is a carcass maximum. Operating pressure is the tyre-information placard on the driver’s door pillar.

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 46 psi as a 20 °C baseline for 215/75R16C.

AmbientGaugeBarkPaNote
−5 °C (hard frost)43 psi2.96 bar296 kPaGauge reads low; do not overfill once warm
0 °C44 psi3.03 bar303 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)45 psi3.1 bar310 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)46 psi3.17 bar317 kPaBaseline for this size sketch
30 °C48 psi3.31 bar331 kPaDo not bleed a hot 215/75R16C
38 °C (heatwave tarmac)49 psi3.38 bar338 kPaDo not bleed a hot 215/75R16C

How to set 215/75R16C

  1. Measure before the school run, not after the motorway.
  2. Write LF / RF / RR / RL. Do not keep 215/75R16C numbers in your head.
  3. Add air in short bursts toward the placard, using 46 psi only as a map.
  4. If one 215/75R16C is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

Cars often seen on 215/75R16C

These catalogue models are often seen on 215/75R16C or a close OEM neighbour. Open the vehicle chart for axle-specific PSI and bar.

If the door sticker and this 215/75R16C page disagree, the sticker wins.

Questions about 215/75R16C

What PSI should 215/75R16C tyres be?

A C-type van planning figure is about 46 psi cold (3.17 bar / 317 kPa). Confirm on the vehicle placard — two cars can share 215/75R16C and not share a sticker.

When does TPMS warn on 215/75R16C?

Direct TPMS typically flags about 25% below target — near 35 psi if you were aiming at 46. Fill to the sticker, not to the lamp.

Is the sidewall number correct for 215/75R16C?

No. Sidewall PSI or kPa is a maximum for the carcass. Operating pressure is the door-pillar placard.

What is 215/75R16C in bar?

46 psi is 3.17 bar. Add a tenth of a bar if the placard’s laden column is higher, which is common on vans that wear this size.

Can I run 215/75R16C at a lower pressure for comfort?

Not as a habit. A soft 215/75R16C cooks the shoulders and dulls steering. Keep load index and stay on the placard.

Handbook: placard · bar vs PSI · cold inflation · all sizes