UK · EU reference Tyre Pressure

235/55R18 · SUV / crossover · Overview

235/55R18 tyre pressure

Size
235/55R18
Class
SUV / crossover
Planning PSI
35
Planning bar
2.41

235/55R18

35 psi / 2.41 bar

241 kPa · estimates for this size class

235/55R18 · 35 psi · 2.41 bar · 241 kPa — estimates. Placard wins.

Searches for “235/55R18 pressure” usually want a number. Use 35 psi (2.41 bar) only as a sketch; the door-pillar placard on the car that wears this size still wins. Under-inflation cooks the shoulders of a 235/55R18; over-inflation wears the centre rib and bangs every cat’s eye.

What 235/55R18 means

235/55R18 means a 235 millimetre section width, a sidewall that is 55 percent of that width, on a 18-inch rim. The R is radial construction.

Plus-size mid-SUV 18-inch. Rim diameter 18 in; section 235 mm. Estimates on this page assume a typical load index for the SUV / crossover class.

Estimated 235/55R18 pressure by load

These 235/55R18 load steps are ± a few PSI from 35. They are not a licence to ignore a printed second column on a van or estate.

ConditionFront (est.)Rear (est.)
Driver only / unladen35 psi / 2.41 bar / 241 kPa37 psi / 2.55 bar / 255 kPa
Typical occupancy36 psi / 2.48 bar / 248 kPa39 psi / 2.69 bar / 269 kPa
Motorway + luggage (sketch)37 psi / 2.55 bar / 255 kPa40 psi / 2.76 bar / 276 kPa

PSI, bar and kPa

Convert around the 235/55R18 band. 2.41 bar is about 35 psi — not 23, not 33 unless the maths says so.

PSIBarkPa
312.14214
322.21221
332.28228
342.34234
352.41241
362.48248
372.55255
382.62262
392.69269
402.76276
412.83283
422.90290
432.96296
443.03303
453.10310
463.17317
473.24324

Placard versus sidewall

This website maps size searches such as “235/55R18 psi”. It does not replace the VIN label. If the two disagree, the label wins.

Cars often seen on 235/55R18

These catalogue models are often seen on 235/55R18 or a close OEM neighbour. Open the vehicle chart for axle-specific PSI and bar.

How to set 235/55R18

  1. Measure before the school run, not after the motorway.
  2. Write LF / RF / RR / RL. Do not keep 235/55R18 numbers in your head.
  3. Add air in short bursts toward the placard, using 35 psi only as a map.
  4. If one 235/55R18 is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 35 psi as a 20 °C baseline for 235/55R18.

AmbientGaugeBarkPaNote
−5 °C (hard frost)32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
0 °C33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)34 psi2.34 bar234 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)35 psi2.41 bar241 kPaBaseline for this size sketch
30 °C37 psi2.55 bar255 kPaDo not bleed a hot 235/55R18
38 °C (heatwave tarmac)38 psi2.62 bar262 kPaDo not bleed a hot 235/55R18

Keep 235/55R18 on the printed band for that car; 35 psi is a size sketch, not a second VIN label.

Questions about 235/55R18

Is the sidewall number correct for 235/55R18?

No. Sidewall PSI or kPa is a maximum for the carcass. Operating pressure is the door-pillar placard.

What is 235/55R18 in bar?

35 psi is 2.41 bar. Add a tenth of a bar if the placard’s laden column is higher, which is common on vans that wear this size.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

Is 235/55R18 the same as a plus-size swap?

Only if that is the size you fitted. Overall diameter should stay close to OEM. Pressure still follows the car, with load index at or above original.

Can I run 235/55R18 at a lower pressure for comfort?

Not as a habit. A soft 235/55R18 cooks the shoulders and dulls steering. Keep load index and stay on the placard.

Handbook: placard · bar vs PSI · cold inflation · all sizes