UK · EU reference Tyre Pressure

245/60R18 · SUV / crossover · Overview

245/60R18 tyre pressure

Size
245/60R18
Class
SUV / crossover
Planning PSI
36
Planning bar
2.48

245/60R18

36 psi / 2.48 bar

248 kPa · estimates for this size class

245/60R18 · 36 psi · 2.48 bar · 248 kPa — estimates. Placard wins.

Searches for “245/60R18 pressure” usually want a number. Use 36 psi (2.48 bar) only as a sketch; the door-pillar placard on the car that wears this size still wins. A 10 °C overnight drop takes roughly 1 psi (0.07 bar) off a closed 245/60R18.

What 245/60R18 means

A 245/60R18 on a SUV / crossover is a geometry. Two cars can share the size and disagree on PSI because mass and axle split differ.

Heavier CUV 18-inch. Rim diameter 18 in; section 245 mm. Estimates on this page assume a typical load index for the SUV / crossover class.

Estimated 245/60R18 pressure by load

Load moves the rear first on a SUV / crossover. If the factory placard already has a laden column, use that — not this sketch for 245/60R18.

ConditionFront (est.)Rear (est.)
Driver only / unladen36 psi / 2.48 bar / 248 kPa36 psi / 2.48 bar / 248 kPa
Typical occupancy36 psi / 2.48 bar / 248 kPa37 psi / 2.55 bar / 255 kPa
Motorway + luggage (sketch)37 psi / 2.55 bar / 255 kPa38 psi / 2.62 bar / 262 kPa

PSI, bar and kPa

Convert around the 245/60R18 band. 2.48 bar is about 36 psi — not 23, not 33 unless the maths says so.

PSIBarkPa
322.21221
332.28228
342.34234
352.41241
362.48248
372.55255
382.62262
392.69269
402.76276
412.83283
422.90290
432.96296
443.03303
453.10310
463.17317
473.24324
483.31331

Placard versus sidewall

The sidewall of a 245/60R18 may say 51 psi or 350 kPa. That is a carcass maximum. Operating pressure is the tyre-information placard on the driver’s door pillar.

Cars often seen on 245/60R18

These catalogue models are often seen on 245/60R18 or a close OEM neighbour. Open the vehicle chart for axle-specific PSI and bar.

How to set 245/60R18

  1. Park so the 245/60R18 tyres are cold (three hours, or less than about a mile).
  2. Read the door-pillar placard for that car — not the 245/60R18 sidewall maximum.
  3. If the sticker is missing, 36 psi / 2.48 bar is only a SUV / crossover planning figure for this size.
  4. Set all four with a calibrated gauge. A 3 psi miss on one corner shows up as a wander.
  5. Refit valve caps and reset TPMS if the handbook asks for a relearn.

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 36 psi as a 20 °C baseline for 245/60R18.

AmbientGaugeBarkPaNote
−5 °C (hard frost)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
0 °C34 psi2.34 bar234 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)35 psi2.41 bar241 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)36 psi2.48 bar248 kPaBaseline for this size sketch
30 °C38 psi2.62 bar262 kPaDo not bleed a hot 245/60R18
38 °C (heatwave tarmac)39 psi2.69 bar269 kPaDo not bleed a hot 245/60R18

Keep 245/60R18 on the printed band for that car; 36 psi is a size sketch, not a second VIN label.

Questions about 245/60R18

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

What is 245/60R18 in bar?

36 psi is 2.48 bar. Add a tenth of a bar if the placard’s laden column is higher, which is common on vans that wear this size.

What is 245/60R18 in kPa?

248 kPa is the planning midpoint (100 kPa = 1 bar). 255 kPa is one PSI higher.

Is the sidewall number correct for 245/60R18?

No. Sidewall PSI or kPa is a maximum for the carcass. Operating pressure is the door-pillar placard.

What PSI should 245/60R18 tyres be?

A SUV / crossover planning figure is about 36 psi cold (2.48 bar / 248 kPa). Confirm on the vehicle placard — two cars can share 245/60R18 and not share a sticker.

Handbook: placard · bar vs PSI · cold inflation · all sizes